Want the display on its own outdoor power point? Book a $50 on-site quote visit online, credited to the job if you go ahead. We fit the weatherproof power point, check the safety switch and leave the switchboard labelled.

Christmas lights are safe when they’re Australian compliant, rated for where you hang them, plugged into a circuit with a working safety switch, and switched off in storms and at bedtime. That’s the Electrical Safety Office’s list, and it covers most of what goes wrong in Brisbane each December: indoor lights on a veranda, a double adaptor doing the work of a power point, and a lead squeezed through a window.
The quick answer
- Look for the regulatory compliance mark or an approval number on the lights, and insulated pins on the plug.
- Outdoor lights need an IP rating of at least IP23. Indoor lights stay indoors, verandas included.
- Test the safety switch before the lights go up. No safety switch on that circuit? Installation starts from $385 including GST.
- Switch outdoor lights off in rain and storms and before bed, and never run a lead across a driveway or through a window.
- An outdoor weatherproof power point starts from $305 installed, so the lead never has to come inside.
Check the lights before they go up
Christmas lights sold in Queensland have to meet Australian safety standards and carry an approval mark, and the Electrical Safety Office’s first warning is about lights bought online from overseas, which often don’t. Last year’s set needs a look too. Unravel it and check the plug, the lead and the lamp holders before it goes anywhere near the roof.
| Check | What you want to see |
|---|---|
| Approval | The regulatory compliance mark, or an approval number such as Q12345 or N12345, on the tag near the plug or on the transformer |
| Plug | Insulated pins. Lights sold after 2006 must have them |
| Lead and holders | No exposed wires, cracks or scorch marks. A damaged lead is a bin job, not a tape job |
| Rating | “Outdoor” on the packaging or the tag if it’s going outside |
| Recalls | Not on the electrical product recall list |
The safest choice for a home display is extra low voltage LED, the 12 or 24 volt sets with a transformer. They run cool and the lead carrying mains voltage stays at the plug. Second hand lights should be checked by a licensed electrician before they’re used, and don’t modify any set to make it fit.
Indoor lights stay indoors
Indoor lights don’t have the weatherproofing outdoor sets do, and the Electrical Safety Office is blunt about it: not outside, not even on a veranda. An outdoor set carries an IP rating such as IP23 or IP44, and the higher the numbers the better it handles rain. IP23 is the minimum for outdoor use. Some outdoor sets also need their transformer kept indoors, so read the tag.
- Secure outdoor lights so wind and storms can’t tear them loose.
- Switch outdoor lights off whenever it rains or a storm comes through.
- Keep flood lights, halogens and other high powered lamps away from anything that can catch fire. They get hot.
- Don’t run leads over walkways or driveways, or through doorways and windows where they’ll be crushed.
- Make every outdoor connection weatherproof. The accessories are cheap.
- No lights around or above the pool, and no leads lying in water.
- Don’t wrap lights around sharp metal, which cuts into the insulation.

Is there a safety switch on the circuit?
This is the one check that protects you if everything else goes wrong. The Electrical Safety Office says to install a safety switch and test it before setting up your lights, and to use a portable safety switch if the circuit doesn’t have one.
Press the test button on the switchboard. The switch should trip straight away, and you reset it. Our safety switch testing and inspection guide shows which switches have the button and what it means if one won’t trip.
Some older switchboards protect the power circuits but not the lighting circuit, and a lot of displays are run off an outside light fitting. If the circuit your lights use isn’t covered, that’s the gap to close before December. Safety switch installation in Brisbane starts from $385 including GST per switch, fitted and tested by a licensed electrician.

Book a $50 quote visit online Call 07 4428 2766
Give the display its own outdoor power point
The lead through the window is how most displays get their power, and it’s the thing most likely to end the season early. The window crushes it, the rain finds the join, and inside the house a double adaptor is carrying three strings of lights and the TV.
The Electrical Safety Office’s advice is to avoid double adaptors and piggy back plugs altogether and to use power boards with overload protection. Several high powered lamps on one circuit can overload it.
The fix is a weatherproof power point on the outside wall, under cover where there is some, on a circuit with a safety switch. An outdoor IP rated power point starts from $305 including GST, and it’s there for every Christmas after this one, the pressure washer and the hedge trimmer. It’s part of our power point installation in Brisbane work and takes a single visit.
What to have ready for the quote visit
- Where the display will go, and where the nearest existing power point is.
- A photo of the switchboard with the door open.
- Whether you want a switch inside for the outdoor point, so the display goes off from the hallway.
If a switch trips or something smells hot
A safety switch that trips when the display comes on is doing its job: something in the set is leaking current. Unplug the display, reset the switch once, and if it holds, plug the strings back in one at a time until it trips again. That string is the fault. If the switch trips with the display unplugged, leave it off and call an electrician, because the problem is in the wiring or a fitting.
A warm plug, a hot lead, a buzzing transformer or a scorched power point means stop. Switch it off at the wall, unplug it and don’t use that set again. In Queensland everything past the plug is licensed electrical work, so a fault in the house wiring is ours to find, not yours.
If the lights have taken a circuit out and it won’t come back, we take electrical emergencies 24 hours a day. An after hours callout is from $245 plus the first hour, and from $295 plus the first hour on weekends and public holidays, with a fixed price before any work starts. Our after hours electrician in Brisbane page lists what’s covered.
Common questions about Christmas lights
Can I leave the lights on all night?
The Electrical Safety Office says to turn decorative lighting off before going to bed or leaving the house. A plug in timer does it for you, and it cuts the power bill too.
Are LED lights safer than the old ones?
Extra low voltage LED sets run cooler and keep mains voltage at the transformer, which is why the Electrical Safety Office lists them as the safest choice. They still need to be outdoor rated if they’re going outside.
How many strings can go on one power board?
There’s no fixed number, because it depends on the lights. Use a power board with overload protection, never a double adaptor, and treat a warm board or a warm lead as the signal that you’ve asked too much of it.
Do you install permanent outdoor lighting?
Yes. Deck lights, garden lights and wall lights on their own switched circuit are everyday work for us, and our outdoor lighting ideas guide shows what’s possible.
Our advice
Spend ten minutes checking the lights and the safety switch before you spend an afternoon hanging them. If the only way to power the display is a lead through a window, have an outdoor power point fitted once, from $305, and the problem is gone for every Christmas after this one.
Get a fixed price for an outdoor power point
Book a $50 on-site quote visit, credited to the job if you go ahead. We fit the weatherproof power point, check the safety switch and leave the board labelled.
Book a $50 quote visit online Call 07 4428 2766
Calls are answered Monday to Friday, 7am to 3:30pm. Online booking is open at any hour. Or send the details online.
Prices current as of 1 November 2026 and include GST. Sources: Electrical Safety Office, Christmas lights; the Faze Electrical & Airconditioning price list. This article is general information. It is not advice about your home’s wiring, which we can only give after looking at the switchboard.

Licensed electricians and ARCtick refrigeration technicians, Queensland Electrical Contractor Licence 90552 and ARCtick L181564. We install and service split systems and do the electrical across Logan, Brisbane southside, Ipswich and the northern Gold Coast.
About Faze | Call 07 4428 2766 | Text 0489 275 747
Get an instant price and book online, any hour
Split system installs, servicing and repairs are priced and booked online in a few minutes, with a 30% deposit now and the balance on the day. For electrical work, book a $50 on-site quote visit, credited to the job if you go ahead.
Get an instant price & book online Call 07 4428 2766
Prices come from our current price list. Every booking has a 2 hour arrival window.


